SUPER DIGITAL

14-1-2. Slim Duct Type
RAV-SM404SDT-E, RAV-SM454SDT-E, RAV-SM564SDT-E
No.
Part name
Procedure
Remarks
XREQUIREMENTX
Be sure to put on gloves at working; otherwise
an injury may be caused by parts, etc.
• Before replacement of the parts, be sure to stop
operation of the air conditioner and turn off
switch of the breaker.
1
Air Filter
1. Detachment
1) Push knobs (3 positions) of the air filter
hooks toward the arrow direction to remove
the air filter.
[In case of sucking system from rear side]
Air filter
Push
2. Attachment
1) Insert the air filter surely into the hooking
grooves (4 positions) at the opposite side of
the hooks, and then fix it to the original
position.
Hook
NOTE)
[In case of sucking system from bottom side]
In case of sucking system from bottom side,
installation direction is determined. Install the
air filter so that hooks are aligned at discharge
side.
Air filter
Hook
Push
2
Plate inlet-A
Plate inlet-B
1. Detachment
1) Take off fixing screws while holding the plate
inlet-A with hands to remove it.
(Sucking system from rear side: Ø4 × 10, 8 pcs)
(Sucking system from bottom side:
Ø4 × 10, 11 pcs)
[In case of sucking system from rear side]
Plate inlet-B: 6 screws
2) Take off fixing screws while holding the plate
inlet-B with hands to remove it.
(Ø4 × 10, 6 pcs)
NOTE)
Plate inlet-A: 8 screws
Be careful that sheeting metal does not fall
when removing the plate inlet.
[In case of sucking system from bottom side]
Plate inlet-A: 11 screws
2. Attachment
1) Using the screws taken off in procedure 1.
2) of 2 , attach the plate inlets in order of B
→ A while holding them not to fall down.
Plate inlet-B: 6 screws
– 191 –