SUPER DIGITAL

Revised 2: Jun., 2008
13-4. Address Setup (Manual setting from remote controller)
In case that addresses of the indoor units will be
determined prior to piping work after cabling work
• Set an indoor unit per a remote controller.
• Turn on power supply.
(Example of 2-lines cabling)
(Real line: Cabling, Broken line: Refrigerant pipe)
Outdoor
1 2 3
Outdoor
1 2 3
1 2 3
Indoor
A B
1 2 3
Indoor
A B
1 2 3
Indoor
A B
1 2 3
Indoor
A B
Line address → 1
Indoor unit address → 1
Group address → 1
1
2
2
2
1
2
2
2
2
1 Push SET + CL + TEST buttons simultaneously
for 4 seconds or more.
2 (← Line address)
Using the temperature setup / buttons,
set 12 to the item code.
3 Using timer time / buttons, set the line address.
4 Push SET button. (OK when display goes on.)
5 (← Indoor unit address)
A B
Remote controller
For the above example, perform setting by
connecting singly the wired remote controller
without remote controller inter-unit cable.
Group address
Individual : 0000
Master unit : 0001
In case of group control
Sub unit : 0002
Using the temperature setup / buttons, set 13 to the item code.
6 Using timer time / buttons, set 1 to the line address.
7 Push SET button. (OK when display goes on.)
8 (← Group address)
Using the temperature setup / buttons, set 14 to the item code.
9 Using timer time / buttons, set 0000 to Individual, 0001 to Master unit, and 0002 to sub unit.
10 Push SET button. (OK when display goes on.)
11 Push TEST button.
Setup completes. (The status returns to the usual stop status.)
2, 5, 8
END 11
TEMP.
FILTER
RESET TEST
TIMER SET
TIME
SET CL
FAN
SAVE
SWING/FIX
ON / OFF
MODE
VENT
UNIT LOUVER
3, 6, 9
4, 7, 10
1
1 2 3 4 5 6 7 8 9 10 11 END
– 178 –