SUPER DIGITAL

More documents

Recommendations

Info

12-4-4. Others 1. Selection of LED display (SW800, SW803 operation) 1) Display selection list The displayed contents of LED D800 to D804 on the outdoor control P.C. board can be exchanged by operation of SW803. Switch SW803 2 3 4 Function / Contents Error display (Error generating at present) Error generating at present is displayed. This switch goes off when an error does not generate. Refer Refer to Page 169. ON ON 1 SW803 2 3 4 1 Error display (The latest error: Latest error including present) After error status was cleared, the error which generated before can be confirmed by this setting. (Reconfirmation is available even if power supply was turned off once.) • If an error generates at present, the same contents as those of error which is generating at present are displayed. • Only error of TO sensor is not displayed by this setting. (Confirm it by setting of error which is generating at present.) Refer to Page 169. TD SW803 TE SW803 TS SW803 Temperature sensor display The detected value of temperature sensor is displayed. Refer to Page 170. ON 1 2 3 4 TO SW803 TL SW803 TH SW803 ON 1 2 3 4 TA SW803 TC SW803 TCJ SW803 ON 1 ON 1 ON 1 2 3 4 2 3 4 2 3 4 ON 1 ON 1 2 3 4 2 3 4 ON 1 ON 1 2 3 4 2 3 4 SW803 2 3 4 Current display The current value which flows in the outdoor unit is displayed. Refer to Page 170. ON 1 SW803 SW803 ON 2 3 4 1 ON 2 3 4 Compressor operation frequency display The operation frequency of the compressor is displayed. Refer to Page 170. 1 PMV opening display The opening of PMV (Pulse Motor Valve) is displayed. Refer to Page 170. – 168 –
2) Error display The error which is generating at present and the latest error (Latest error information including present) can be confirmed by lighting LED D800 toD804 on the outdoor control P.C. board. a) When all DIP switch SW803 are OFF, the status of error which is generating at present is displayed. b) only of DIP switch SW803 is turned on, the error which generated before (Latest error information including present) is displayed.a) c) If there is an error, any of LED D800 to D804 goes on. (Display 1) d) When pushing the pushdown button switch SW800 for approx. 1 second, the display is exchanged. (Display 2) e) When pushing SW800 again or after 2 minutes, the status returns to that of Display . Present error SW803 ON 2 3 4 1 Latest error SW803 ON 2 3 4 1 (Legend) l D800 (Yellow) l D801 (Yellow) ¥ D802 (Yellow) l D803 (Yellow) l D804 (Yellow) ¡ D805 (Green) l : Go off, ¡ : Go on, ¥ : Flash Display 1) (Initial display) lllll¡ ¡¡ll¡¡ ll¡l¡¡ l¡¡l¡¡ ¡¡¡l¡¡ Display 2) (SW800 operation) lllll¡ ll¥ll¡ l¥¥ll¡ ¥¥¥ll¡ lll¥l¡ ll¥¥l¡ ¥l¥¥l¡ ¥¥¥¥l¡ ¥¥¥¥¥¡ ¥llll¡ l¥lll¡ ¥¥lll¡ ll¥ll¡ l¥l¥l¡ ¥l¥¥¥¡ ¥¥¥¥¥¡ ¥¥lll¡ ¥l¥ll¡ ¥¥¥ll¡ ¥¥¥¥l¡ ¥¥ll¥¡ ll¥l¥¡ l¥¥l¥¡ l¥l¥¥¡ ¥l¥¥¥¡ Error contents Normal Discharge temp. sensor (TD) error Heat exchanger temp. sensor (TE) error Heat exchanger temp. sensor (TL) error Outside temp. sensor (TO) error Suction temp. sensor (TS) error Heat sink temp. sensor (TH) error Heat exchanger sensor (TE, TS) miswiring EEPROM error Compressor break down Compressor lock Current detection circuit error Case thermostat operation Model unset Communication error between MCU Other error (Compressor disorder, etc.) Discharge temp. error Power supply error Heat sink overheat error Gas leak detection 4-way valve reverse error High pressure protective operation Fan system error Driving element short-circuit Position detection circuit erro Wired remote controller Error code — F04 F06 F06, F07 F08 F06, F12 F13, L29 F06, F15 F31, L29 H01 H02 H03 H04, P04 L10, L29 L29 Error is not determined. P03 P04, P05 P07, L29 P15, L29 P19, L29 P04, P20 P22 P26 P29 ∗ As the error code displayed on the wired remote controller may differ according to type of indoor model, multiple codes are described. – 169 –
Page 1 and 2:
SERVICE MANUAL FILE NO. A07-003 Rev
Page 3 and 4:
7. REFRIGERANT R410A ..............
Page 5 and 6:
WARNING Check earth wires. Prohibit
Page 7 and 8:
• New Refrigerant (R410A) This ai
Page 9 and 10:
1. SPECIFICATIONS Revised 2: Jun.,
Page 11 and 12:
Revised 2: Jun., 2008 Indoor unit
Page 13 and 14:
1-1-2. Concealed Duct Type Model I
Page 15 and 16:
1-1-3. Under Ceiling Type Revised
Page 17 and 18:
1-1-4. High Wall Type Revised 2: J
Page 19 and 20:
1-1-5. Compact 4-Way Cassette (600
Page 21 and 22:
1-1-6. Slim Duct Type Model Coolin
Page 23 and 24:
Revised 2: Jun., 2008 Indoor unit 1
Page 25 and 26:
1-2. Outdoor Unit Model name Outdo
Page 27 and 28:
1-3. Operation Characteristic Curve
Page 29 and 30:
2. CONSTRUCTION VIEWS (EXTERNAL VIE
Page 31 and 32:
Revised 2: Jun., 2008 RAV-SM1104UT-
Page 33 and 34:
- 33 - 365 17.5 17.5 74 Drain hole
Page 35 and 36:
RAV-TWP30E2, RAV-TWP50E2 (Simultane
Page 37 and 38:
3-2. Outdoor Unit RAV-SP1104AT-E, S
Page 39 and 40:
4-1. Slim Duct (Filter Attached) 4.
Page 41 and 42:
5-1-2. Slim Duct Type RAV-SM404SDT-
Page 43 and 44:
- 43 - CAUTION : HIGH VOLTAGE The h
Page 45 and 46:
6-2. Outdoor Unit (Parts Ratings) R
Page 47 and 48:
Table 7-2-1 Thicknesses of annealed
Page 49 and 50:
43˚to 45˚ 45˚to 46˚ B A C D Fig
Page 51 and 52:
1) Be sure to make setting so that
Page 53 and 54:
7-6. Instructions for Re-use Piping
Page 55 and 56:
Revised 2: Jun., 2008 7-6-6. Handli
Page 57 and 58:
7-6-8. Recovery method of refrigera
Page 59 and 60:
8-1-2. Connection of Wireless Remot
Page 61 and 62:
8-2. Control Specifications No. Ite
Page 63 and 64:
No. Item Outline of specifications
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Optional power supply CN309 (Yellow
Page 77 and 78:
- 77 - L-phase power supply lead (B
Page 79 and 80:
3. Outdoor fan control SP110 SP140
Page 81 and 82:
7. Current release value shift cont
Page 83 and 84:
1. Pulse Motor Valve (PMV) control
Page 85 and 86:
2) Heating fan control The outdoor
Page 87 and 88:
10-1. Summary of Troubleshooting 1
Page 89 and 90:
10-2. Troubleshooting 10-2-1. Outli
Page 91 and 92:
10-2-2. Others (Other than Check Co
Page 93 and 94:
- 93 - Check Code List (Outdoor) Re
Page 95 and 96:
Error mode detected by indoor unit
Page 97 and 98:
Error mode detected by outdoor unit
Page 99 and 100:
10-2-4. Diagnostic Procedure for Ea
Page 101 and 102:
Revised 2: Jun., 2008 [E18 error] I
Page 103 and 104:
[P10 error] Is connection of float
Page 105 and 106:
[F02 error] Revised 2: Jun., 2008
Page 107 and 108:
[E03 error] (Master indoor unit) [
Page 109 and 110:
Check code Outdoor LED display Che
Page 111 and 112:
Page 113 and 114:
Check code [L29] Outdoor LED displa
Page 115 and 116:
Page 117 and 118: Check code Outdoor LED display Che
Page 119 and 120: Temperature sensor Temperature - Re
Page 121 and 122: Lamp indication Check code Cause of
Page 123 and 124: - 123 - Check Code List (Outdoor) R
Page 125 and 126: Error mode detected by remote contr
Page 127 and 128: 10-2-9. Diagnostic Procedure for Ea
Page 129 and 130: [E18 error] Is inter-unit cable of
Page 131 and 132: [P10 error] Revised 2: Jun., 2008
Page 133 and 134: [F02 error] Revised 2: Jun., 2008
Page 135 and 136: [E03 error] (Master indoor unit) [
Page 137 and 138: Check code [F12] [Suction temp. sen
Page 139 and 140: Check code [P22] [Fan system error]
Page 141 and 142: 11. REPLACEMENT OF SERVICE P.C. BOA
Page 143 and 144: Revised 2: Jun., 2008 Setting 4-way
Page 145 and 146: Revised 2: Jun., 2008 Table 1. Sett
Page 147 and 148: 12-1. Indoor Unit 12. SETUP AT LOCA
Page 149 and 150: Procedure 1 2 Turn on power of the
Page 151 and 152: 12-1-4. Function Selection Setup P
Page 153 and 154: DN Item Contents At shipment from f
Page 155 and 156: 12-1-6. Monitor Function of Remote
Page 157 and 158: n Indoor unit power-ON sequence Pow
Page 159 and 160: 4. Wiring specifications • Use 2-
Page 161 and 162: 2. How to confirm the central contr
Page 163 and 164: 4. How to set louver lock (Louver f
Page 165 and 166: Be sure to make ceiling setting whe
Page 167: 12-4-3. Service Support Function (L
Page 171 and 172: 4) Specific operation for maintenan
Page 173 and 174: 13. ADDRESS SETUP Revised 2: Jun.,
Page 175 and 176: 13-2-2. Automatic Address Example f
Page 177 and 178: Revised 2: Jun., 2008 13-3. Remote
Page 179 and 180: 13-5. Confirmation of Indoor Unit N
Page 181 and 182: 14. DETACHMENTS Revised 2: Jun., 20
Page 183 and 184: No. Part name Procedure Remarks 4 C
Page 185 and 186: No. Part name Procedure Remarks 6 D
Page 187 and 188: No. Part name Procedure Remarks 7 F
Page 191 and 192: 14-1-2. Slim Duct Type RAV-SM404SDT
Page 193 and 194: No. Part name Procedure Remarks 5 P
Page 199 and 200: No. Part name Procedure Remarks 4 R
Page 203 and 204: No. Part name Procedure Remarks 7 P
Page 211 and 212: 15. EXPLODED VIEWS AND PARTS LIST R
Page 213 and 214: RAV-SM564UT-E, RAV-SM804UT-E, RAV-S
Page 215 and 216: RBC-AX31U (W)-E, RBC-AX31U (WS)-E 3
Page 217 and 218: Revised 2: Jun., 2008 Location No.
Page 219 and 220:
15-2. Outdoor Unit RAV-SP1104AT-E,
Page 221 and 222:
RAV-SP1104AT-E, RAV-SP1104ATZ-E, RA
Page 223 and 224:
Location No. Part No. Description 1
Page 225 and 226:
WARNINGS ON REFRIGERANT LEAKAGE Che
show all

SUPER DIGITAL

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?