SUPER DIGITAL
SUPER DIGITAL
SUPER DIGITAL
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Check<br />
code<br />
Outdoor<br />
LED display<br />
<br />
Check and troubleshooting<br />
(Item without special mention Indicates part of outdoor unit.)<br />
[P22]<br />
<br />
¡ l<br />
¡ ¥<br />
¡ ¥<br />
l l<br />
¡ ¥<br />
¡ ¡<br />
[Fan system error]<br />
Is there no problem on power supply voltage?<br />
(198 to 264V)<br />
YES<br />
Does the fan rotate without trouble when rotating<br />
shaft of fan motor with hands during power-OFF?<br />
Is there no problem on coil resistance of fan motor?<br />
Between red and white lead wire : 12 to 20Ω<br />
Between white and black lead wire : 12 to 20Ω<br />
Between black and red lead wire : 12 to 20Ω<br />
NO<br />
Check wiring construction.<br />
Ask repair of power supply.<br />
YES<br />
NO<br />
Replace fan motor.<br />
Check outdoor P.C. board.<br />
Defect → Replace<br />
Single operation check for outdoor fan<br />
1) Set SW804 of Dip switch as the following figure and then push SW801 for<br />
approx. 1 second to check single operation of outdoor fan. Use this method to<br />
check which fan, upper or lower fan, has a trouble.<br />
• When pushing SW801 for 1 second<br />
again or 2 minutes passed, the fan stops. Outdoor fan single operation<br />
2) After check, turn off all Dip switch<br />
SW804 SW801<br />
SW804.<br />
ON<br />
1 2 3 4<br />
Push<br />
[P26]<br />
<br />
¡ l<br />
¡ ¥<br />
¡ l<br />
l ¥<br />
¡ ¥<br />
¡ ¡<br />
[Short-circuit of compressor drive element]<br />
Is there no problem on connection<br />
of compressor lead or reactor?<br />
(Check referring to Wiring diagram.)<br />
YES<br />
The same error does not occur in<br />
operation without compressor lead.<br />
NO<br />
NO<br />
Correct wiring.<br />
Replace outdoor P.C. board.<br />
YES<br />
Check compressor. (Rear short, etc.)<br />
Defect → Replace<br />
[P29]<br />
—<br />
No code<br />
<br />
¡ ¥<br />
¡ l<br />
¡ ¥<br />
l ¥<br />
¡ ¥<br />
¡ ¡<br />
<br />
l ¥<br />
¡ ¥<br />
¡ ¥<br />
l ¥<br />
¡ ¥<br />
¡ ¡<br />
[Position detection circuit error]<br />
Check outdoor P.C. board.<br />
Defect → Replace<br />
[Other error] Compressor disorder due to sudden change of load, etc.<br />
∗ Although the display of outdoor LED outputs, the unit automatically restarts<br />
and error is not determined.<br />
∗ LED display also may output due to negative phase of compressor or wire<br />
coming-off.<br />
– 118 –