General Information Gates/Rohloff - Koga Signature

More documents

Recommendations

Info

4 for Frame builders • Frame requirements when mounting the Gates Carbon Drive • Possibilities for tensioning and adjustment • Straightness and stiffness of the frame 34
for Frame builders Frame requirements when mounting the Gates Carbon Drive Opening the frame A specific rear triangle is required for mounting the Gates Carbon Drive System. Since the belt cannot be separated and rejoined like a bike chain, it has to be possible to open the frame at the rear triangle. This opening should allow a gap of at least 8mm. There are several possible solutions, depending upon desired style. Illustrations1 and 2 show a frame with the opening at the dropout. A separation of the right chainstay or at the seatstay of the frame is also possible. (Illustration 3). 4 Illustration 1: Opening the frame to mount the belt Possibilities for tensioning and adjustment It has to be possible to tension and adjust the belt after it is mounted in the frame. This ispossible through the use of either adjustable dropouts (illustration 2) or with an eccentric adjuster around the bottom bracket. However, the safety of the belt can only be guaranteed if the correctly adjusted tension is not altered when the rear wheel is dismounted (in the case of a puncture, for example). The frame construction must allow for this. www.carbondrivesystems.com 35
Page 1 and 2: Manual for the Gates Carbon Drive S
Page 3 and 4: 1 first steps • Congratulations!
Page 5 and 6: first steps 1 Have your bike checke
Page 7 and 8: first steps 1 Mounting the tensione
Page 9 and 10: first steps 1 7. 8. 1. Drive belt n
Page 11 and 12: mounting Mounting the Gates Carbon
Page 13 and 14: mounting 2 Illustration 3: Correct
Page 15 and 16: mounting Checking the belt tension
Page 17 and 18: mounting Checking the belt tension
Page 19 and 20: mounting axle. If the Snubber is lo
Page 21 and 22: mounting 2 Shim ring for bottom bra
Page 23 and 24: mounting Mounting the Gates Carbon
Page 25 and 26: mounting Lubricate the inner thread
Page 27 and 28: mounting Ensure that the surfaces o
Page 29 and 30: mounting Removing the Gates-Rohloff
Page 31 and 32: exchange When does the Gates Carbon
Page 33: exchange Profile Wear Gauge Illustr
Page 37 and 38: 5 Gear Ratio Comparisum • Compari
Page 39 and 40: atio overview 19 Teeth rear 20 Teet
Page 41 and 42: atio overview Sprocket-size combina
Page 43: Find more information for Europe: U

General Information Gates/Rohloff - Koga Signature

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?