download - Knoll

Cascade edge worksurfaces
Curvilinear Corner
Morrison
description A B C h pattern no solid woodgrain
Curvilinear corner 36 24 24 1 1 /8 MCE1L3636SSN $533. $614.
42 24 24 1 1 /8 MCE1L4242SSN 644. 740.
42 24 30 1 1 /8 MCE1L4242SDN 765. 878.
42 30 24 1 1 /8 MCE1L4242DSN 765. 878.
48 24 24 1 1 /8 MCE1L4848SSN 723. 832.
48 24 30 1 1 /8 MCE1L4848SDN 866. 996.
48 30 24 1 1 /8 MCE1L4848DSN 866. 996.
48 30 30 1 1 /8 MCE1L4848DDN 777. 894.
Worksurface Planning
Order Code
Example: MCE1L4848SSG-114
MCE1 Cascade edge
worksurface
L Curvilinear ‘‘L’’ top
48 Width
48 Depth
S 24d, left side
S 24d, right side
G Grommet
114 Surface finish
L Grain direction
Specification Information
Specify:
Grommet / no grommet.
Replace the ‘‘N’’ suffix from the
pattern number with ‘‘G’’. Add $40.
Finish:
Solid:
114 Folkstone Grey
117 Soft Grey
118 Bright White
119 Pumice
Woodgrain:
124 Medium Cherry
125 Natural Maple
126 Natural Cherry
127 Walnut
Note: When wood grain or brushed
finishes are specified on Cascade
corner worksurfaces with two ‘‘A’’
sides of equal length that do not
exceed 42 you must select one of
three grain direction options. Insert
the desired grain direction ‘‘L’’ =
Left hand, ‘‘R’’ = Right hand or ‘‘D’’
= Diagonal after the worksurface
finish code to indicate the
appropriate grain direction. When
the ‘‘D’’ option is selected please
add $25.00 to the worksurface list
price. 48 Cascade corners are not
available with a diagonal grain
option.
145
Application Notes
Cascade Edge worksurfaces are
wrapped with a pvc free, 3D
laminate sheet heated and pressed
around an FSC certified substrate.
3D laminate is more susceptible to
denting, impact, tearing and
marring than conventional high
pressure laminate and should be
handled with care. Do not drag
worksurfaces across any flooring
surface. Treat Cascade Edge
worksurfaces like veneer
worksurfaces for optimum
performance under normal
conditions. Cascade Edge
worksurfaces have a 10 year
warranty that covers defects in
workmanship and materials. This
warranty does not cover damage
occurring during or after
installation.
Cascade Edge worksurfaces and are
not drilled for wire management
clips, pedestals or brackets.
Cascade Edge worksurfaces are for
panel-based planning only and
cannot be used in conjunction with
Network desk supports.
Worksurfaces are 1 /16 less than
nominal width and 3/8 less than
nominal depth for rear wire
clearance.
Edge grommets are centered at rear
edge of worksurface for maximun
clearance of 1 3 /8
Worksurfaces require support every
48 in width. All supporting
hardware is ordered separately.
Worksurfaces may be supported by
left or right hand 18 cantilever
brackets at the rear corner, and
cantilever bridging brackets on each
side edge.
Panel supported worksurfaces over
48 must be mid-span supported by
cantilever brackets, specified
separately.
Order Morrison brackets with wood
screws (suffix -W ).