download - Knoll

Base Raceway Electrical
Power Modules, Power Jumpers
Specifications
Dividends Horizon
Base Raceway Electrical
Power can be distributed through the base raceway.
Three systems are available:
Modular components are used to distribute
power through the base raceway and consist of:
All electrical components and data cables are
field-installed.
CAUTION: DO NOT CONNECT POWER
UNTIL INSTALLATION IS COMPLETE.
CONNECTION TO THE BUILDING
POWER SOURCE MUST BE PERFORMED
BY A LICENSED ELECTRICIAN.
Power Modules
Power modules are the primary electrical
components for distributing electrical within panels.
They are also the only components that accept
duplex receptacles and power infeeds for access.
Panels 24" and wider can accept power modules.
18" wide panels only accept power jumpers.
Power modules consist of terminal blocks
at each end connected by a hard-wired
metal conduit. The terminal blocks
accept duplex receptacles or power
infeeds. Power modules snap into integral
channels in base raceways and can be
accessed on one or both panel sides.
Power Jumpers
Power jumpers connect between power modules
in non-adjacent panels. Power jumpers take the
duplexes to provide pass-through power.
Three versions are available:
Single panel power jumpers carry power
from a panel with a power module
through a single non-electrified panel to
an adjacent panel with a power module
when a post connector is not involved.
Single panel power jumpers with post
carry power from a panel with a power
module through a single non-electrified
panel and post connector to an adjacent
panel with a power module.
Multiple panel power jumpers carry power
from a panel with a power module through
multiple panels with or without a post
to the next available power module.
Base Raceway Electrical
Power
Module
Power
Connector
Power
Module
Electrical/Data
Components
Power Jumper
Power Module
Power Module
Connection
Base Infeed
Power Module
Power Jumper
181