download - Knoll

Panel Wall Starter, Panel-to-Panel Top Cap Transition
Off-Module Panel Connector
Specifications
Dividends Horizon
Panel Wall Starter
Panel wall starters mount to reinforced
building walls to begin a perpendicular
topway or full view panel run. Wall starters
consist of a wall bracket and upper and lower
panel-mounting brackets. Wall fasteners are
not included or supplied by Knoll. Choice
of wall fasteners is critical and must be
selected to match the wall construction,
wall surface and loading conditions.
Wall starters are available in all Dividends
Horizon panel heights. Black finish only.
NOTE: KNOLL, INC. ASSUMES
NO RESPONSIBILITY FOR WALL
CONSTRUCTION OR PERFORMANCE
OF FASTENERS USED.
Off-Module Panel Connector
The off-module connector allows for panel
attachment anywhere along the width of
the perpendicular panel. The off-module
connector can be used with same height
topway or full view panels only. The connector
consists of a height specific connector and
attaching hardware. The 3-way (DP1PT3)
or 4-way (DP1PT4) post top cap must be
ordered separately when radius metal top
caps are being used. Specify connector height
to match panel height. Black finish only.
When using the off-module panel connector,
the attached connector will deface the
perpendicular fabric panel insert.
Electrical components and data cables cannot
be routed through the off-module panel.
Panel-to-Panel Top Cap Transition
Top cap transitions fill the gap between
panel top cap sections in straight
panel-to-panel configurations.
radiused molded plastic
in straight, same-height panel configurations
NOTE: PANEL-TO-PANEL TOP CAP
TRANSITIONS ARE ORDERED
SEPARATELY FROM PANELS.
Panel Wall Starter Connection
Off-Module Panel Connector
Panel-To-Panel Transition for
Enhanced Smooth Panel Trim
Panel
Panel
Wall
Starter
140