LINEAR MOTION SOLUTIONS - Brd. Klee A/S

Rail Assembly - CCR
Ceramic Coated Aluminum
CCR - ceramic coated - rail assembly
• Aluminum alloy base material
• RC70 ceramic coated finish
• One piece integrated design eliminates assembly time
• Weld splatter, paints, and other contaminants will not
stick to the shaft
• Non-magnetic and vibration resistant
• Economical, weight saving alternative to traditional
steel shafting
• Designed to run with Simplicity Frelon GOLD ® lined
linear bearings
L
• Available pre-drilled and undrilled*
D
C
A
B
y X F
Rail Assembly - Ceramic
E
Nominal
shaft
size Diameter Tolerance A B C D E F Hole Spacing
Max.
Length
Weight
Part No.
(in.) Min. Max. .002 Bolt Hole X y *(ft.) (lbs./in.)
CCR08-xx 1/2 0.4988 0.4996
1.500 0.250 0.188 1.000 #6 0.169
0.019
1.125
4 2
CCR10-xx 5/8 0.6238 0.6246 1.625 0.313
1.125 #8 0.193 0.030
CCR12-xx 3/4 0.7488 0.7496 1.500 1.750 0.375 0.250 1.250 #10 0.221
CCR16-xx 1 0.9988 0.9996 1.750 2.125 0.500 1.500 1/4" 0.281 6 3 10' 0.076
CCR20-xx 1-1/4 1.2488 1.2496 2.125 2.500 0.563 0.313 1.875
0.119
5/16" 0.343
CCR24-xx 1-1/2 1.4987 1.4995 2.500 3.000 0.688 0.375 2.250
0.172
8 4
CCR32-xx 2 1.9985 1.9995 3.250 3.750 0.875 0.500 2.750 3/8" 0.406 0.305
NoteS: Specify length in part number using inches. Example: for 1/2" shafting total length 36" long = CCR08-36.
Cut-to-length rails may not be coated on the ends.
Customer specifies “y” dimension.
DO NOT use with linear ball bearings.
*Undrilled rails are vailable on special request.
0.043
800.962.8979 • www.pbclinear.com 67