LINEAR MOTION SOLUTIONS - Brd. Klee A/S

Hevi-Rail ® Linear Bearing Systems
Mounting Configurations
SELECTION GUIDE (when used with Profile Rails HVR-S to HVR-6)
Use the following chart to select the bearings (fixed or adjustable), rails, flange plates and clamp flanges according to your
system’s maximum static radial and axial loading. A “system” is defined as a bearing in the corresponding rail. For dimensional and
detailed specifications for the system selected, simply refer to the corresponding pages.
F (KN)
MAX STAT RADIAL
F (KN)
MAX STAT AXIAL
COMBINED BEARING
AXIAL BEARING FIXED
COMBINED BEARNG
AXIAL BEARING ADJUSTABLE
PROFILE RAILS CLAMP FLANGE FLANGE PLATE PAGE NO.
5.2 1.7 HVB-053 – HVR-S – HVPS-1 246
7.2 2.4 HVB-054 HVBEA-454 HVR-0 HVC-0 HVP0-1 244
8.6 2.8 HVB-055 HVBEA-455 HVR-1, HVRI-07 HVC-1 HVP1-1 248
8.9 3.0 HVB-056 HVBEA-456 HVR-2 HVC-2 HVP2-1 249
8.9 3.0 HVB-057 HVBEA-457 HVRI-08 – HVP2-1 250
15.6 5.2 HVB-058 HVBEA-458 HVR-3, HVRI-09 HVC-3 HVP3-1 251
15.5 5.1 HVB-059 HVBEA-459 HVRI-10 – – 252
16.5 5.5 HVB-060 HVBEA-460 HVRI-11 – – 252
16.5 5.5 HVB-061 HVBEA-461 HVR-4 HVC-4 HVP4-1 253
23.5 7.8 HVB-062 - HVR-5 – HVP4-1 254
41.1 13.7 HVB-063 HVBEA-463 HVR-6 – HVP6-1 255
NOTE: For cantilevered loads, static verification calculations can be found on page 244. *All dimensions in mm.
MOUNTING CONFIGURATIONS
HANDLING UNITS
ADJUSTABLE CLAMP SYSTEM
A
LIFTING UNITS
Mounting Configurations
HORIZONTIAL TELESCOPE
800.962.8979 • www.pbclinear.com 245