LINEAR MOTION SOLUTIONS - Brd. Klee A/S
LINEAR MOTION SOLUTIONS - Brd. Klee A/S
LINEAR MOTION SOLUTIONS - Brd. Klee A/S
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Simplicity ® Linear Slides<br />
Technical Information<br />
SLIDE SELECTION INFORMATION<br />
MODEL NUMBER<br />
1. Determine the size and stroke of slide.<br />
2. Is a lube system required?<br />
3. Please furnish the following to the factory:<br />
a. Model designation<br />
b. Lube system requirements<br />
c. Mounting orientation, saddle position if mounted<br />
at an angle<br />
d. Load to be carried and approximate center of gravity<br />
from saddle center<br />
e. Location and magnitude of any force which resists the<br />
motion of the slide<br />
f. Acceleration rate and maximum velocity of the saddle<br />
g. Deceleration rate<br />
h. Service life requirements<br />
i. Type of environment the slide will operate in<br />
–<br />
–<br />
Series Code Size Code Length Code<br />
–<br />
Ball Screw<br />
Lead Code<br />
MOUNTING ORIENTATION<br />
Please indicate the parameters of your application in the boxes below.<br />
HORIZ. VERT. ANGLE<br />
SADDLE<br />
UP<br />
Angle<br />
HORIZ.<br />
ANGLE<br />
SADDLE<br />
DOWN<br />
Angle<br />
HORIZ.<br />
Cycle Rate:<br />
Max. Saddle Velocity:<br />
Acceleration Rate:<br />
Deceleration Rate:<br />
Load:<br />
Per Hour:<br />
Inch/Second:<br />
Inches/Second 2 :<br />
Inches/Second 2 :<br />
lbs.<br />
Per Minute:<br />
LOCATION OF CENTER OF GRAVITY FROM SADDLE CENTER<br />
Please indicate the parameters of your application in the boxes below.<br />
C.G.<br />
Linear Slides<br />
SLIDE<br />
DRIVE<br />
*RESISTING<br />
FORCE (If Present)<br />
*Example of “Resisting Force” would be tool thrust for a drill head mounted on slide.<br />
Resisting Force:<br />
Life Requirement:<br />
lbs.<br />
Strokes<br />
Hours<br />
800.962.8979 • www.pbclinear.com 159