Ethernet Communication Module IFD9506

More documents

Recommendations

Info

Ethernet Communication Module IFD9506 11 Application Example – WPLSoft You can set up IFD9506 by WPLSoft software. See the examples below for how to set up the communication connection. Columns in every setup page in WPLSoft are the same as those in DCISoft. Please refer to section 10 for relevant settings. 11.1 Setting up IP through WPLSoft Application Steps Setting up network parameters of IFD9506 directly from the PC. (1) The IP of the PLC executing WPLSoft is “192.168.1.2”. (2) Subnet mask: 255.255.255.0; Gateway: 192.168.1.254 (3) Modify the network parameter of IFD9506. (4) Connecting the PC and IFD9506 by RJ-45 network cable. Note: Both PC and IFD9506 cannot adopt DHCP but static IP. 1. The connections: 2. Open “Communication Setting” in WPLSoft. 52 DVP-PLC Application Manual
Ethernet Communication Module IFD9506 3. Select “Ethernet” and press “OK”. 4. Press “broadcast” icon to search for all IFD9506 modules on the network. DVP-PLC Application Manual 53
Page 1:
IFD9506 Ethernet Communication Modu
Page 4 and 5: Ethernet Communication Module IFD95
Page 62: Ethernet Communication Module IFD95
show all

Ethernet Communication Module IFD9506

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?