Ethernet Communication Module IFD9506

Ethernet Communication Module IFD9506
user by E-Mail.
• Mail settings
1. Mail alarm setup:
There are 3 mail alarms to be set up. Check the boxes to enable the alarms. The alarm can be
triggered by “low" and “high”.
2. SMTP server:
When Alarm 1 is triggered, the E-Mail will first be sent to SMTP server, and SMTP server will send it
to the designated address. For example, assume there is an E-Mail to be sent to Test@delta.com.tw,
and SMTP server is 192.168.0.1, the E-Mail will be sent to SMTP server first, and the server will
further send it to the recipient Test1@delta.com.tw.
3. E-Mail of sender:
Maximum 63 Engligh characters are allowed.
4. Subject of E-Mail:
You can enter the text message in the column, and the message will be placed in the subject of the
E-Mail and sent to the recipient. IFD9506 is able to contain 1~3 E-Mail subjects. Max. 63 English
characters are allowed for each subject.
5. E-Mail of recipient:
One mail can be sent to 10 addresses according to the alarm setting. Every address allows Max. 63
English characters. For example, (see the figure above) when Alarm 1 is triggered, the E-Mail will be
sent to Test1@delta.com.tw. When Alarm 2 is triggered, the E-Mail will be sent to
Test2@delta.com.tw.
Note:
To correctly send out E-Mails, there has to be a SMTP server in the network. When we send out an
E-Mail, the mail will be sent to SMTP server first, and the server will further send the mail to the
designated address.
22
DVP-PLC Application Manual