DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

2. Programming Concepts
DABSR:
1. M1029= ON when instruction is completed.
2. When the instruction is re-executed for the next time, M1029 will turn off first then ON again
when the instruction is completed
ZRN, DRVI, DRVA:
1. M1029 will be “ON” after Y0 and Y1 pulse output is completed. M1102 will be “ON” after Y2
and Y3 pulse output is compeleted.
2. When the instruction is re-executed for the next time, M1029 / M1102 will turn off first then
ON again when the instruction is completed.
Function Group
Number
Contents:
Clear Instruction
M1031, M1032
M1031 (clear non-latched memory) , M1032 (clear latched memory)
Device
M1031
Clear non-latched area
M1032
Clear latched area
Devices will be cleared
Contact status of Y, general-purpose M and general-purpose S
• General-purpose contact and timing coil of T
• General-purpose contact, counting coil reset coil of C
• General-purpose present value register of D
• General-purpose present value register of T
• General-purpose present value register of C
Contact status of M and S for latched
• Contact and timing coil of accumulative timer T
• Contact and timing coil of high-speed counter C for latched
• Present value register of D for latched
• Present value register of accumulative timer T
• Present value register of high-speed counter C for latched
Function Group
Number
Contents:
Output State Latched in STOP mode
M1033
When M1033 = ON, PLC outputs will be latched when PLC is switched from RUN to STOP.
Function Group
Number
Contents:
Disabling all Y outputs
M1034
When M1034 = ON, all outputs will turn off.
2-61