DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

DVP-ES2/SX2/SS2/SA2/SX2/SE Operation Manual – Programming
API Mnemonic Operands Function
274 D BORI
Type
Connect NC Contact in Parallel
by Specified Bit
Controllers
ES2/EX2 SS2 SA2 SX2
SE
Bit Devices Word devices Program Steps
OP X Y M S K H KnX KnY KnM KnS T C D E F BORI: 5 steps
S * * * * * * DBORI: 9 steps
n * * * * * * * * * * *
Operands:
S: Reference source device n: Reference bit
PULSE 16-bit 32-bit
ES2/EX2 SS2 SA2
SA2
SA2
SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2
SE SE SE SX2
Explanations:
1. For ES2/EX2 models, only V1.20 or above supports the function
2. Available range for the value in operand n: K0~K15 for 16-bit instruction; K0~K31 for 32-bit
instruction.
3. BORI instruction is used to connect NC contact in parallel, whose state is defined by the
reference bit n in reference device D, i.e. if the bit specified by n is ON, the NC contact will be
ON, and vice versa.
Program Example:
X0
BORI D0 K0
Y1
Instruction: Operation:
LD X0 Load NO contact X0
BORI D0 K0 Connect NC contact in
parallel, whose state is
defined by bit0 of D0
OUT Y1 Drive coil Y1
3-482