DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

DVP-ES2/EX2/SS2/SA2/SX2 Operation Manual - Programming
API Mnemonic Operands Function
199 D ICF Immediately change frequency
Controllers
ES2/EX2 SS2 SA2
SE
SX2
Type
Bit Devices Word devices Program Steps
OP X Y M S K H KnX KnY KnM KnS T C D E F
S 1 *
S 2 * * *
D *
DVSPO: 13 steps
PULSE 16-bit 32-bit
ES2/EX2 SS2 SA2
SA2
SA2
SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2
SE SE SE SX2
Operands:
S 1 : Target frequency to be changed S 2 : Gap time and gap frequency D: Pulse output
device (Y0, Y2)
Explanations:
1. Max frequency for S 1 : 100kHz. When ICF instruction executes, frequecy changing will start
immediately with ramp-up/down process.
2. ICF instruction has to be executed after the execution of DVSPO or DPLSY instructions.
When the instruction is used together with DVSPO, operands S 1 , S 2 , D of DICF has to be
assigned the same device with S 1 , S 3 , D of DVSPO. When the instruction is used with DPLSY,
operands S 1 and D has to be assigned the same device with S 1 and D of DPLSY.
3. If ICF instruction is used with DPLSY instruction, operand S 2 is invalid.
4. When ICF instruction is used with DVSPO instruction, parameter setting of S 2 functions the
same as S 3 in DVSPO instruction, specifying the gap time and gap frequency of
ramp-up/down process.
5. D pulse output device supports only Y0 and Y2.
6. The instruction is suggested to be applied in interrupt subroutines for obtaining the better
response time and eexecution results
7. For associated flags and registers, please refer to Points to note of API 198 DVSPO
instruction.
Function Explanations:
1. If users change the target frequency by using DVSPO instruction, the actual changing timing
will be delayed due to the program scan time and the gap time as below.
3-450