DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

DVP-ES2/EX2/SS2/SA2/SX2 Operation Manual - Programming
Y
(0,0)
X
(-27000,-27000)
(27000,-27000)
(0,-55000)
2. Steps:
a) Set the four coordinates (-27000, -27000), (0, -55000), (27000, -27000) and (0,0) (as the
figure above). Place them in the 32-bit registers (D200, D202), (D204, D206), (D208, D210),
(D212, D214).
b) Design instructions as follows.
c) RUN the PLC. Set ON M0 to start the 2-axis line drawing.
= D0 K1 DPPMA D200 D202 K100000 Y0
= D0 K2 DPPMA D204 D206 K100000 Y0
= D0 K3 DPPMA D208 D210 K100000 Y0
= D0 K4 DPPMA D212 D214 K100000 Y0
M0
RST
M1029
ZRST D1336 D1339
MOV
K1
D0
M0
M1029
INCP
D0
END
3. Operation:
When PLC runs and M0 = ON, PLC will start the first point-to-point motion by 100KHz. D0 will
plus 1 whenever a point-to-point motion is completed and the second point-to-point motion will
start to execute automatically. The operation pattern repeats until the fourth point-to-point
motion is completed.
3-428