DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

DVP-ES2/EX2/SS2/SA2/SX2/SE Operation Manual - Programming
‘0’ ‘F’: toward the drive at address 15
‘1’ ‘0’: toward the drive at address 16
… and so on, max. address: 254 (‘FE’)
Function code:
‘0’ ‘3’: read contents from multiple registers
‘0’ ‘6’: write one word into a single register
‘1’ ‘0’: write contents to multiple registers
Data characters:
The data sent by the user
LRC checksum:
LCR checksum is 2’s complement of the value added from Address to Data Characters.
For example: 01H + 03H + 21H + 02H + 00H + 02H = 29H. 2’s complement of 29H = D7H.
End word (END):
Fix the END as END Hi = CR (0DH), END Lo = LF (0AH)
Example:
Read 2 continuous data stored in the registers of the drive at address 01H (see the table
below). The start register is at address 2102H.
RTU mode
Inquiry message:
Response message:
STX ‘: ’ STX ‘: ’
Address
‘0’ ‘0’
Address
‘1’
‘1’
Function code
‘0’ ‘0’
Function code
‘3’
‘3’
‘2’ Number of data ‘0’
‘1’
(count by byte) ‘4’
Start address
‘0’ ‘1’
‘2’
Content of start
‘7’
address
‘0’ 2102H
‘7’
Number of data ‘0’
‘0’
(count by word) ‘0’ ‘0’
‘2’ Content of address ‘0’
LRC Checksum
‘D’ 2103H
‘0’
‘7’
‘0’
END
CR ‘7’
LRC Checksum
LF
‘1’
END
CR
LF
Field Name
START
Descriptions
Refer to the following explanation
3-222