DVP-ES2-EX2-SS2-SA2-SX2-Operation Manual

DVP-ES2/EX2/SS2/SA2/SX2/SE Operation Manual - Programming
Ladder Diagram
Structure
Explanation Instruction Available Devices
Multiple output branches
MPS
MRD
MPP
None
Output coil OUT Y, M, S
S Step ladder STL S
Basic / Application
instruction -
Basic instructions and API
instructions. Please refer to
chapter 3 Instruction Set
Inverse logic INV None
1.5.1 Creating a PLC Ladder Program
The editing of the program should start from the left side bus line to the right side bus line, and from
up to down. However, the right side bus line is omitted when editing in WPLSoft. A single row can
have maximum 11 contacts on it. If more than 11 contacts are connected, a continuous symbol “0”
will be generated automatically and the 12th contact will be placed at the start of next row. The
same input points can be used repeatedly. See the figure below:
0
X0 X1 X2 X3 X4 X5 X6 X7 X10 C0 C1
X11 X12 X13
0
Y1
When evaluating the user program, PLC scan starts from left to right and proceeds to next row
down until the PLC reaches END instruction. Output coils and basic / application instructions
belong to the output process and are placed at the right of ladder diagram. The sample program
below explains the execution order of a ladder diagram. The numbers in the black circles indicate
the execution order.
X0 X1 Y1 X4
M0
T0 M3
X3 M1
Y1
TMR T0 K10
1-6