Maintenance and Repair Manual - saf-holland
Maintenance and Repair Manual - saf-holland Maintenance and Repair Manual - saf-holland
E) Installation instructions Removing the wheel bearing assembly Lever out the retaining ring using a screwdriver. Place a drift against the joint of the two wheel bearings and drive the bearing inner races out of the wheel hub together with the seal rings. Drive the bearing outer races out of the hub housing using a normal workshop drift. Thoroughly clean the hub housing. Installing the wheel bearing assembly Drive both bearing outer races into the hub housing until they bottom. Use installation tool, SAF Part No. 3 434 1043 00. Pack the space between the bearing outer race and shoulder with long-life grease. Coat the taper roller bearing with the remaining grease. Distribute the grease supplied in the repair kit uniformly over both bearings and use up completely. 28
E) Installation instructions Place the bearing inner races into the hub. Secure both bearing inner races with the retaining ring. Pack the ring gap on the face side of the bearing with long-life grease. Fit the seal rings. Press the seal rings into the hub on both sides using the installation tool, SAF Part No. 3 434 1043 00, until they are flush with the edge of the hub. If the hubs are subsequently painted, ensure that the contact surface for the wheel and brake drum are not painted. 29
- Page 1 and 2: Maintenance and Repair Manual Axle
- Page 3 and 4: Contents This manual is intended fo
- Page 5 and 6: A) Component Description The compon
- Page 7 and 8: B) General safety instructions Plea
- Page 9 and 10: C) Maintenance instructions Axle ty
- Page 11 and 12: C) Maintenance instructions Axle ty
- Page 13 and 14: D) Spare part designation Axle type
- Page 15 and 16: D) Spare part designation Axle type
- Page 17 and 18: E) Installation instructions The co
- Page 19 and 20: E) Installation instructions Ensure
- Page 21 and 22: E) Installation instructions The br
- Page 23 and 24: E) Installation instructions Check
- Page 25 and 26: E) Installation instructions Comple
- Page 27: E) Installation instructions Repair
- Page 31 and 32: F) Slack adjuster Automatic slack a
- Page 33 and 34: G) Track control Commercially avail
- Page 35 and 36: H) Service tools 1. Lever for hub c
- Page 37 and 38: I) Tightening torque in Nm The foll
E) Installation instructions<br />
Place the bearing inner races into the hub.<br />
Secure both bearing inner races with the retaining ring.<br />
Pack the ring gap on the face side of the bearing with long-life<br />
grease.<br />
Fit the seal rings.<br />
Press the seal rings into the hub on both sides using the installation<br />
tool, SAF Part No. 3 434 1043 00, until they are flush with the edge<br />
of the hub.<br />
If the hubs are subsequently painted, ensure that the contact surface<br />
for the wheel <strong>and</strong> brake drum are not painted.<br />
29