Policy Framework Configuration Guide - Juniper Networks

Chapter 16: Summary of Traffic Sampling, Forwarding, and Monitoring Configuration Statements
source-address-only (MX Series routers only)—Include only the source IP address in the
payload in the hash key.
destination-address-only (MX Series routers only)—Include only the destination IP address
in the payload in the hash key.
NOTE: You can include either the source-address-only or the
destination-address-only statement, not both. They are mutually exclusive.
layer-4 (MX Series routers only)—Include Layer 4 information from the packets’ IP payload
in the hash key.
NOTE: On MX Series routers only, you can configure either Layer 3 or Layer
4 load balancing, or both at the same time.
Required Privilege
Level
Related
Documentation
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
• Configuring Load Balancing Based on MAC Addresses on page 149
• Configuring VPLS Load Balancing Based on IP and MPLS Information on page 150
• Configuring VPLS Load Balancing on MX Series Ethernet Services Routers on page 151
Copyright © 2010, Juniper Networks, Inc.
401