Policy Framework Configuration Guide - Juniper Networks

Junos 10.4 Policy Framework Configuration Guide
NOTE: You cannot simultaneously include the interface-group statement at
the [edit firewall family inet filter filter-name term term-name from] hierarchy
level and configure an egress forwarding table filter. The egress forwarding
table filter is applied to transit packets only.
NOTE: The egress forwarding table filter is not supported for the J Series
Services Routers.
NOTE: In Junos OS Release 8.4 and later, you can no longer configure this
output statement for VPLS. You can continue to configure ingress forwarding
table filters with the input statement at the [edit forwarding-options family
vpls filter] hierarchy level.
To apply a forwarding table filter to a flood table, include the flood and input statements
at the [edit forwarding-options family family-name] hierarchy level:
[edit forwarding-options family vpls]
flood {
input filter-name;
}
NOTE: The flood statement is valid for the vpls protocol family only.
Configuring IPv6 Accounting
You can configure the routing platform to track IPv6-specific packets and bytes passing
through the router.
Configuring Discard Accounting
To enable IPv6 accounting, include the route-accounting statement at the [edit
forwarding-options family inet6] hierarchy level:
[edit forwarding-options family inet6]
route-accounting;
By default, IPv6 accounting is disabled. If IPv6 accounting is enabled, it remains enabled
after a reboot of the router. To view IPv6 statistics, issue the show interface statistics
operational mode command. For more information about this command, see the Junos
OS Interfaces Command Reference.
On routing platforms containing a Monitoring Services PIC or an Adaptive Services PIC,
you can configure accounting for traffic passing through the routing platform.
364
Copyright © 2010, Juniper Networks, Inc.