Policy Framework Configuration Guide - Juniper Networks

Junos 10.4 Policy Framework Configuration Guide
if-exceeding
Syntax if-exceeding {
bandwidth-limit bps;
bandwidth-percent number;
burst-size-limit bytes;
}
Hierarchy Level
[edit firewall policer policer-name],
[edit logical-systems logical-system-name firewall policer policer-name]
Release Information Statement introduced before Junos Release 7.4.
Logical systems support introduced in Junos Release 9.3.
Description
Configure policer rate limits.
Options
bandwidth-limit bps—Traffic rate, in bits per second (bps). Any value below 61,040 bps
results in an effective rate of 30,520 bps for all routers except the T640, T1600, and
TX Matrix routers.
Range: 8,000 through 50,000,000,000 bps (on the MX Series, M7i, M10i, M120, M320,
T640, T1600, and TX-Matrix routers)
Range: 32,000 through 50,000,000,000 bps (on any platform except for the MX Series,
M7i, M10i, M120, M320, T640, T1600, and TX-Matrix routers)
Default: None
bandwidth-percent number—Port speed, in decimal percentage number.
Range: 1 through 100
Default: None
burst-size-limit bytes—Maximum burst size. The minimum recommended value is the
maximum transmission unit (MTU) of the IP packets being policed.
Range: 1500 through 100,000,000,000 bytes
Default: None
Required Privilege
Level
Related
Documentation
firewall—To view this statement in the configuration.
firewall-control—To add this statement to the configuration.
• Rate Limiting on page 280
324
Copyright © 2010, Juniper Networks, Inc.