Policy Framework Configuration Guide - Juniper Networks

Junos 10.4 Policy Framework Configuration Guide
user@host# set mpls interface all
user@host# set mpls interface fxp0.0 disable
user@host# set bgp group int type internal
user@host# set bgp group int local-address 10.255.19.77
user@host# set bgp group int family inet any
user@host# set bgp group int family l2vpn signaling
user@host# set bgp group int neighbor 10.255.71.214
user@host# set bgp group int neighbor 10.255.19.79
user@host# set ospf traffic-engineering
user@host# set ospf area 0.0.0.0 interface lo0.0
user@host# set ospf area 0.0.0.0 interface ge-2/0/0.0
user@host# set ospf area 0.0.0.0 interface ge-2/0/1.0
user@host# set ospf area 0.0.0.0 interface ge-2/0/2.0
user@host# set ospf area 0.0.0.0 interface ae0.0
user@host# set ospf area 0.0.0.0 interface ae1.0
user@host# set ospf area 0.0.0.0 interface all
user@host# set ospf area 0.0.0.0 interface fxp0.0 disable
user@host# set ldp interface all
user@host# set ldp interface fxp0.0 disable
user@host# exit
3. Configure VPLS on PE1.
[edit]
user@host# edit routing-instances vpls
[edit routing-instances vpls]
user@host# set instance-type vpls
user@host# set interface ge-2/0/4.0
user@host# set route-distinguisher 65000:1
user@host# set vrf-target target:65000:1
user@host# set protocols vpls site-range 3
user@host# set protocols vpls no-tunnel-services
user@host# set protocols vpls site 2 site-identifier 2
user@host# set protocols vpls site 2 interface ge-2/0/4.0
user@host# set protocols vpls vpls-id 100
user@host# exit
Results
From configuration mode, confirm your configuration by entering the show
forwarding-options, show interfaces, show policy-options, show protocols, and show
routing-instances commands. If the output does not display the intended configuration,
repeat the configuration instructions in this example to correct it.
PE1:
user@host# show forwarding-options
hash-key {
family multiservice {
source-mac;
destination-mac;
payload {
ip {
layer-3;
}
}
}
158
Copyright © 2010, Juniper Networks, Inc.