Policy Framework Configuration Guide - Juniper Networks

Junos 10.4 Policy Framework Configuration Guide
user@host# set ge-0/1/6 gigether-options 802.3ad ae0
user@host# set ge-0/2/2 encapsulation ethernet-vpls
user@host# set ge-0/2/2 unit 0 family vpls
user@host# set ge-0/2/3 gigether-options 802.3ad ae0
user@host# set ge-0/2/6 gigether-options 802.3ad ae0
user@host# set ge-0/3/0 gigether-options 802.3ad ae0
user@host# set ge-0/3/1 gigether-options 802.3ad ae0
user@host# set ge-0/3/6 gigether-options 802.3ad ae0
user@host# set ge-1/0/6 gigether-options 802.3ad ae0
user@host# set ge-1/2/6 unit 0 family inet address 13.1.1.2/30
user@host# set ae0 unit 0 family inet address 11.11.11.1/30
user@host# set ae0 unit 0 family iso
user@host# set ae0 unit 0 family mpls
user@host# exit
2. On PE1, configure the packet header data to be used for per-flow load balancing.
[edit]
user@host# edit forwarding-options hash-key family multiservice
[edit forwarding-options hash-key family multiservice]
set source-mac
set destination-mac
set payload ip layer-3
user@host# exit
3. Configure the routing policy on PE1.
[edit]
user@host# edit policy-options
[edit policy-options]
user@host# set policy-statement exp-to-fwd term a from community grn-com
user@host# set policy-statement exp-to-fwd term a then install-nexthop lsp
PE1-to-PE2
user@host# set policy-statement exp-to-fwd term a then accept
user@host# set policy-options community grn-com members target:65000:1
user@host# exit
4. Configure PE1’s routing protocols and MPLS.
[edit]
user@host# edit protocols
[edit protocols]
user@host# set rsvp interface all
user@host# set rsvp interface fxp0.0 disable
user@host# set mpls label-switched-path PE1-to-PE2 to 10.255.19.77
user@host# set mpls label-switched-path PE1-to-PE3 to 10.255.19.79
user@host# set mpls interface all
user@host# set mpls interface fxp0.0 disable
user@host# set bgp group int type internal
user@host# set bgp group int local-address 10.255.71.214
user@host# set bgp group int family inet any
user@host# set bgp group int family l2vpn signaling
user@host# set bgp group int neighbor 10.255.19.77
user@host# set bgp group int neighbor 10.255.19.79
user@host# set ospf traffic-engineering
user@host# set ospf area 0.0.0.0 interface all
user@host# set ospf area 0.0.0.0 interface fxp0.0 disable
156
Copyright © 2010, Juniper Networks, Inc.