Policy Framework Configuration Guide - Juniper Networks

Chapter 6: Extended Actions Configuration
}
}
}
NOTE: You must also configure either the label-1 or no-labels statement at
the [edit forwarding-options hash-key family mpls] hierarchy level.
You can configure load balancing for IPv4 traffic over Ethernet pseudowires to include
only Layer 3 IP information in the hash key. To include only Layer 3 IP information, include
the layer-3-only option at the [edit forwarding-options family mpls hash-key payload ip]
hierarchy level:
[edit forwarding-options]
hash-key {
family mpls {
(label-1 | no-labels);
payload {
ip {
layer-3-only;
}
}
}
}
NOTE: You must also configure either the label-1 or no-labels statement at
the [edit forwarding-options hash-key family mpls] hierarchy level.
Configuring Load Balancing Based on MAC Addresses
To load-balance traffic based on Layer 2 media access control (MAC) information, include
the family multiservice statement at the [edit forwarding-options hash-key] hierarchy
level:
family multiservice {
destination-mac;
source-mac;
}
To include the destination-address MAC information in the hash key, include the
destination-mac option. To include the source-address MAC information in the hash key,
include the source-mac option.
NOTE: You can configure per-packet load balancing to optimize VPLS traffic
flows across multiple paths. For more detailed information, see the Junos
VPNs Configuration Guide.
Copyright © 2010, Juniper Networks, Inc.
149