SERVICE MANUAL - JUKI
SERVICE MANUAL - JUKI SERVICE MANUAL - JUKI
SECTION 2 - 15 PAGE 3 B - Needle touches back of needle hole (Fig. b - PAGE 2). 1 Loosen screws (11), (12) of setting plate (10) for lower shaft bush. However, lower shaft bush (13) must not float. (Big clearance should not be made between setting plate and bush.) 2 Moving lower shaft gear assy (14) to left (C). Lower shaft gear (8) must always engage with shuttle shaft gear. 3 Loosen screws (4), (5). 4 Adjust needle clearance to shuttle by moving shuttle race assy to wards you (B direction - PAGE 2) and tighten screws (4), (5). 5 Move lower shaft gear assy (14) along shaft and adjust backlash be tween lower shaft gear (8) and shuttle shaft gear (9). 6 Tighten screws (11), (12). ※ Check following "Checking rotating direction of shuttle race assy" (next page) and "2 - 15 Needle timing to shuttle" after adjustment.
Checking rotating direction of shuttle race assy: Align needle with the right edge (B) of cut portion (A). SECTION 2 - 15 PAGE 4 Checking backlash of shuttle shaft gear and lower shaft gear: 1. Remove bobbin case, shuttle cover, and shuttle hook. 2. Turning hand wheel, rotate shuttle driver (1) and locate the point of minimum backlash. 3. Check if the backlash is approximately zero at this point.
- Page 1 and 2: ® SEWING MACHINE HZL-25Z SERVICE M
- Page 3 and 4: 3. Face cover SECTION 1 PAGE 2 Disa
- Page 5 and 6: 5. FRONT COVER Disassembling 1. Rem
- Page 7 and 8: 7. Hand wheel SECTION 1 PAGE 6 Re-a
- Page 9 and 10: 2 - 1 L - R positioner SECTION 2 -
- Page 11 and 12: 2 - 3 Needle Position at Zigzag Sti
- Page 13 and 14: 2 - 5 Feed Dog Height SECTION 2 - 5
- Page 15 and 16: 2 - 7 Feed Dog Lateral positioning
- Page 17 and 18: SECTION 2 -8 PAGE 2 Lateral Movemen
- Page 19 and 20: 2 - 10 Buttonhole sewing - "0" feed
- Page 21 and 22: SECTION 2 - 12 PAGE 1 2 - 12 Balanc
- Page 23 and 24: 2 - 14 Needle Height SECTION 2 - 14
- Page 25: Adjustment if needle touches needle
- Page 29 and 30: 2 - 17 Control panel pointer positi
- Page 31 and 32: 2 - 19 Hooking Fork Position of Nee
- Page 33 and 34: 2 - 20 Bobbin Winder SECTION 2 - 20
- Page 35: ® 8-2-1, KOKURYO-CHO, CHOFU-SHI, T
Checking rotating direction of shuttle race assy:<br />
Align needle with the right edge (B) of cut portion (A).<br />
SECTION 2 - 15<br />
PAGE 4<br />
Checking backlash of shuttle shaft gear and lower shaft gear:<br />
1. Remove bobbin case, shuttle cover, and shuttle hook.<br />
2. Turning hand wheel, rotate shuttle driver (1) and locate the point of minimum<br />
backlash.<br />
3. Check if the backlash is approximately zero at this point.