You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Adjustment if needle touches needle hole:<br />
SECTION 2 - 15<br />
PAGE 2<br />
1. Bring needle at center of needle hole following the method of "2 - 15<br />
Needle Clearance to Shuttle (Adjustment)".<br />
2. Remove gear cover.<br />
3. Following adjustment is to be made depending on situation.<br />
A - Needle touches front of needle hole (Fig. a ).<br />
1 Loosen screws (4), (5).<br />
2 Adjust needle clearance to shuttle by moving shuttle race assy (6)<br />
away from you (A) and tighten screws (4), (5).<br />
3 Loosen two screws (7). Adjust backlash between lower shaft gear<br />
(8) and shuttle shaft gear (9) and tighten two screws (7).