You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2 - 15 Needle Clearance to Shuttle<br />
SECTION 2 - 15<br />
PAGE 1<br />
Checking:<br />
1. Remove bobbin case and shuttle race cover.<br />
2. Set #14 needle.<br />
3. Set machine at "Straight Stitch A" by turning selector dial.<br />
4. Turning hand wheel, bring the shuttle point to the center line of needle.<br />
5. Check if needle clearance to shuttle point (A) is 0 to 0.1 mm.<br />
6. Needle must not touch needle hole.<br />
Adjustment:<br />
1. Remove face cover.<br />
2. Remove screw (1), and loosen screw (2).<br />
3. Move the shaft (3) of supporting assy.<br />
To increase clearance ð Move shaft (3) away from you.<br />
To decrease clearance ð Move shaft (3) towards you.<br />
4. After adjustment, tighten screw (2) keeping shaft (3) from moving.<br />
5. Tighten screw (1).<br />
※ Check if needle does not touch needle hole after adjustment.<br />
If needle touches needle hole, following adjustment is to be made.<br />
Backward<br />
Forward