Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 - 14 Needle Height<br />
SECTION 2 - 14<br />
PAGE 1<br />
Checking:<br />
1. Remove presser foot.<br />
2. Set selector dial at "Straight Stitch A".<br />
3. Turning hand wheel, bring the needle bar to its highest position.<br />
4. Check and see if the distance between needle point and needle plate surface<br />
is about 14.6 mm.<br />
Adjustment:<br />
1. Remove face plate.<br />
2. Loosen screw (2) of needle bar clamp (1).<br />
3. Vertically sliding needle bar, correct the needle height.<br />
4. Tighten screw (2) securely checking needle hole side after adjustment.<br />
NOTE: After adjustment, follow "2 - 19 Replacement of needle hole threader lever".