You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
2 - 13 Presser Foot Height<br />
SECTION 2 - 13<br />
PAGE 1<br />
Checking:<br />
1. Lower feed dog below the needle plate.<br />
2. Lift up presser foot lever.<br />
3. Check and see if clearance (A) between needle plate and presser foot is<br />
about 5.5 mm.<br />
Adjustment:<br />
1. Remove face cover.<br />
2. Loosen screw (2) of presser bar clamp (1) and adjust the height by vertically<br />
sliding presser bar (3).<br />
3. Tighten screw (2) securely after adjustment, keeping alignment of the foot<br />
against feed dog.
Change language