Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 - 7 Feed Dog Lateral positioning<br />
SECTION 2 - 7<br />
PAGE 1<br />
Checking:<br />
1. Set machine for "maximum stitch length".<br />
2. Check if the groove of needle plate touches left end of feed dog.<br />
3. Check if noise is not made.<br />
4. Check if feed dog keeps alignment against groove of needle plate.<br />
Adjustment:<br />
1. Remove gear cover.<br />
2. Adjustment for above (Checking 2 and 3)<br />
• Loosen screw (2) of setting plate (1), and adjust by moving horizontal<br />
shaft assy (3).<br />
3. Adjustment for above (Checking 4).<br />
• Loosen 2 screws (4). Feed dog (5) must touch groove (6) of needle plate<br />
correctly.