Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 - 6 Feed dog Longitudinal positioning<br />
SECTION 2 - 6<br />
PAGE 1<br />
Checking:<br />
1. Set stitch length at maximum, and selector dial at "Straight Stitching A".<br />
2. Turning hand wheel, move feed dog to the rear end position, and see if rear<br />
edge of center front dog keeps clearance (A) to the needle plate hole.<br />
3. Move feed dog to the front end, and see if front edge of center dog keeps<br />
clearance (B) to the needle plate hole.<br />
Adjustment:<br />
1. Remove side cover.<br />
2. Move feed dog to its extreme front end position.<br />
3. Loosen screw (2). Moving feed dog forward or backward, adjust the angle<br />
of arm (3) against feed shaft (4).<br />
4. Tighten screw (2) securely after adjustment, keeping the angle of the arm<br />
as adjusted.