User Manual - John Preston
User Manual - John Preston User Manual - John Preston
– Pull the armrest [2] completely out of the holder [4]. – Loosen the two screws [6] located underneath the upholstery [5]. – Push the moveable part [7] to the desired position. – Tighten the two screws [6] again. 4 2 – Push the armrest [2] back into the holder [4]. – Screw the armrest [2] back onto the side support [8]. 6 7 6 5 4 2 8 2
1.3 Armrest sideways adjustment 9 – Tilt the entire seat [9] forwards. – Loosen the two screws [10] located under the seat. – Push the complete armrest [2] into the desired position. 2 10 – Tighten the two screws [10] again. – Fold the seat carefully back down onto the chassis. Check the position of the armrest [2] in relation to the direction indicators. ! If the armrest bumps into the direction indicators, then they will have to be adjusted too (see chapter 1.14).
- Page 1 and 2: Adventure A10 Informationen für Th
- Page 3 and 4: Contents 1 Mechanical adjustments
- Page 5: 1 Mechanical adjustments to the adv
- Page 9 and 10: 1.5 Backrest angle of inclination a
- Page 11 and 12: 10 1.7 Seat length adjustment Funct
- Page 13 and 14: 12 1.9 Leg support length adjustmen
- Page 15 and 16: 14 1.11 Leg support footrest length
- Page 17 and 18: 16 1.13 Adjusting the chassis sprin
- Page 19 and 20: 18 31 1.14 Setting the direction in
- Page 21 and 22: 20 1.16 Setting the seat position S
- Page 23 and 24: 22 1.17.2 Mudguards for the powered
- Page 25 and 26: 2 Settings on the control unit 24 2
- Page 27 and 28: 26 Turning speed - Determines the m
- Page 29 and 30: 28 Speed reduction This parameter c
- Page 31 and 32: 30 2.6 Changing the parameters Afte
- Page 33 and 34: 32 2.8 Parameter table 2.8.1 advent
- Page 35 and 36: 34 2.8.3 adventure version 12 km/h
- Page 37 and 38: 36 Drive symbol flashes Exclamation
- Page 39 and 40: 38 Drive symbol flashes Exclamation
- Page 41 and 42: 40 Interface symbol flashes Exclama
- Page 43 and 44: 42 Complete seat unit* flashes Inte
- Page 45 and 46: 44 Brake symbol flashes Battery cap
– Pull the armrest [2] completely out of the holder [4].<br />
– Loosen the two screws [6] located underneath the<br />
upholstery [5].<br />
– Push the moveable part [7] to the desired position.<br />
<br />
– Tighten the two screws [6] again.<br />
4<br />
2<br />
– Push the armrest [2] back into the holder [4].<br />
– Screw the armrest [2] back onto the side support [8].<br />
6 7 6<br />
5<br />
4<br />
2<br />
8<br />
2