User Manual - John Preston
User Manual - John Preston User Manual - John Preston
1.15 Setting the seat position Function seat 19 34 33 – Loosen the screws [34] on both sides of the holder stay [33]. – Pull or push on the holder stay [33] so that the entire seat holder moves into the desired position. – Firmly tighten the two screws [34] on both sides of the holder stay [33] again.
20 1.16 Setting the seat position Standard seat 35 33 – Loosen and remove the screws [35] on both sides of the holder stay [33]. – Place the holder stay [33] against the hole positions desired. – Screw the holder stay [33] tight again using the screws [35].
- Page 1 and 2: Adventure A10 Informationen für Th
- Page 3 and 4: Contents 1 Mechanical adjustments
- Page 5 and 6: 1 Mechanical adjustments to the adv
- Page 7 and 8: 1.3 Armrest sideways adjustment 9 -
- Page 9 and 10: 1.5 Backrest angle of inclination a
- Page 11 and 12: 10 1.7 Seat length adjustment Funct
- Page 13 and 14: 12 1.9 Leg support length adjustmen
- Page 15 and 16: 14 1.11 Leg support footrest length
- Page 17 and 18: 16 1.13 Adjusting the chassis sprin
- Page 19: 18 31 1.14 Setting the direction in
- Page 23 and 24: 22 1.17.2 Mudguards for the powered
- Page 25 and 26: 2 Settings on the control unit 24 2
- Page 27 and 28: 26 Turning speed - Determines the m
- Page 29 and 30: 28 Speed reduction This parameter c
- Page 31 and 32: 30 2.6 Changing the parameters Afte
- Page 33 and 34: 32 2.8 Parameter table 2.8.1 advent
- Page 35 and 36: 34 2.8.3 adventure version 12 km/h
- Page 37 and 38: 36 Drive symbol flashes Exclamation
- Page 39 and 40: 38 Drive symbol flashes Exclamation
- Page 41 and 42: 40 Interface symbol flashes Exclama
- Page 43 and 44: 42 Complete seat unit* flashes Inte
- Page 45 and 46: 44 Brake symbol flashes Battery cap
1.15 Setting the seat position<br />
Function seat<br />
19<br />
34<br />
33<br />
– Loosen the screws [34] on both sides of the holder stay<br />
[33].<br />
– Pull or push on the holder stay [33] so that the entire seat<br />
holder moves into the desired position.<br />
– Firmly tighten the two screws [34] on both sides of the<br />
holder stay [33] again.