TGA Buddy Manual - Value Mobility Scooters
TGA Buddy Manual - Value Mobility Scooters
TGA Buddy Manual - Value Mobility Scooters
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
11. Your batteries should be given a full charge cycle before use (see battery charging section).<br />
TILLER ADJUSTMENT<br />
The tiller is uniquely designed to give adjustment for a<br />
comfortable driving position. It can also be moved for ease<br />
of access to the scooter or folded flat for storage.<br />
To tilt simply pull the lever as shown at fig 7, pull or push<br />
the tiller to the desired position and release lever. Rock the<br />
tiller gently to secure it in position.<br />
Care! Warning – Make sure the tiller is locked before<br />
using the scooter and also if you have lifted the armrests<br />
for ease of access make sure they are locked down before<br />
use.<br />
Fig 7<br />
CONTROLS<br />
ON/OFF KEY SWITCH – Located in the centre at the rear<br />
of the control console. Fig 8-1. Switch by inserting the key<br />
and turning clockwise. You will note the green “ON” light<br />
will illuminate as will the lights on the battery condition<br />
indicator. Your <strong>Buddy</strong> is ready for use. To switch off<br />
simply turn the key back to the vertical position. Never<br />
leave switched on when the scooter is not in use. Not only<br />
is this dangerous, but it will drain the battery. Make sure<br />
you remove the key when the scooter is unattended.<br />
Care! Warning - Never switch off when the scooter is<br />
moving except in case of emergency. Failure to observe<br />
this will result in the motor brake being applied suddenly<br />
and placing you in a dangerous situation. In addition<br />
continual use of this mode may cause undue stress to the<br />
drive system and damage the main electronic control unit.<br />
Be extremely cautious on slopes. Sit upright in your seat<br />
or your machine could become less stable.<br />
Fig 8<br />
STATUS LIGHT - This is the green light on the control console next to the battery condition indicator. It will come on to show<br />
the machine is ready for use. It has another function as well, which is to flash various fault codes if the machine has a fault.<br />
This is explained further on in this manual.<br />
BATTERY CONDITION INDICATOR – When you switch <strong>Buddy</strong> on you will see the battery condition indicator lights come on Fig<br />
8-2. There are four lights in total and when they are all lit they are showing the batteries to be fully or nearly fully charged.<br />
When only one light is either lit or flashing, it is showing the batteries to be very low on charge and should be recharged as soon<br />
as possible.<br />
Listed below is an indication of the percentage discharge shown by each of the four lights<br />
4 lights - will show when 100% charged and remain on until charge drops to 75%<br />
3 lights - will show when 75% charged and remain on until charge drops to 50%<br />
2 lights - will show when 50% charged and remain on until charge drops to 25%<br />
1 light - will show when 25% charged and remain on until charge drops to 10%<br />
1 light flashing - will flash when charge drops to 10% which is approximately equal to 1mile of normal use<br />
6