Operating Manual - John Morris Scientific
Operating Manual - John Morris Scientific
Operating Manual - John Morris Scientific
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Ultra-Low Refrigerated Circulators<br />
7. Troubleshooting guide / Error messages<br />
XXXXX<br />
ALARM<br />
CODE 01<br />
+<br />
XXXXX<br />
WARNING<br />
CODE 40<br />
Alarm with a complete shutdown of the unit<br />
Whenever the microprocessor electronics registers a failure, a complete<br />
shutdown of the heater and circulating pump is performed. The alarm<br />
light „ “ illuminates and a continuous signal tone sounds.<br />
The VFD-COMFORT-DISPLAY indicates the cause for the alarm in form<br />
of a code.<br />
Warning without a complete shutdown of the unit<br />
The VFD-COMFORT-DISPLAY indicates the cause for the warning in<br />
form of a code and an acoustic signal sounds in regular intervals.<br />
These messages appear every 10 seconds.<br />
Press enter<br />
to quit the audible signal.<br />
ALARM<br />
CODE 01<br />
Insufficient liquid<br />
level or float is<br />
defective.<br />
Press to indicate the help text in the LCD DIALOG-DISPLAY when<br />
alarm messages appear.<br />
<br />
<br />
<br />
The circulator is operated without bath fluid, or the liquid level is<br />
insufficient. Replenish the bath tank with the bath fluid.<br />
Tube breakage has occured (insufficient filling level due to excessive<br />
bath fluid pumped out). Replace the tubing and replenish the bath<br />
tank with the bath fluid.<br />
The float is defect (e. g., because damaged in transit). Repair by<br />
authorized JULABO service personnel.<br />
ALARM<br />
CODE 02<br />
Control cable of<br />
cooling machine<br />
interrupted during<br />
Operation.<br />
<br />
During the self-test after switch-on a short-circuit is registered<br />
between pin 2 and pin 4 of the control cable or the control cable is<br />
interrupted during operation.<br />
Reconnect the cable or eliminate the short-circuit.<br />
WARNING<br />
CODE 03<br />
WARNING<br />
CODE 04<br />
ALARM<br />
CODE 03<br />
Actual temperature<br />
above high temperature<br />
value.<br />
ALARM<br />
CODE 04<br />
Actual temperature<br />
below low temperature<br />
value.<br />
<br />
Excess temperature warning<br />
or<br />
Excess temperature alarm<br />
Warn-Type: Set to<br />
>Warning< or >Alarm<<br />
<br />
Low temperature warning<br />
or<br />
Low temperature alarm.<br />
Warn-Type: Set to<br />
>Warning< or >Alarm<<br />
63
Change language