Operating Manual - John Morris Scientific

Ultra-Low Refrigerated Circulators
6.8. ATC Absolute Temperature Calibration, 3-point calibration
ATC serves to compensate a temperature difference that might occur between
circulator and a defined measuring point in the bath tank because of physical
properties.
Limits
Interface serial
>ATCalibration
Pump
ESC
ESC
ATCalibration
>Sensor : intern
Status : no /yes
Type : 3-point /1-point/2-point
TmpValue1: xx.xx°C
CalValue1: xx.xx°C
TmpValue2: xx.xx°C
CalValue2: xx.xx°C
TmpValue3: xx.xx°C
1
CalValue3: xx.xx°C
internal
ESC
ATCalibration
>Sensor : extern
Status : no /yes
Type : 3-point /1-point/2-point
TmpValue1: xx.xx°C
CalValue1: xx.xx°C
TmpValue2: xx.xx°C
CalValue2: xx.xx°C
external
1
TmpValue3: xx.xx°C
CalValue3: xx.xx°C
Sensor: >internextern<
Calibration can be carried out for the internal temperature sensor and
for the external temperature sensor connected to the socket „ext.
Pt100“.
The circulator is able to store both parameter sets. However, only the
one set under this menu item is indicated.
Status:
>no< The controller of the circulator uses the original curve of
the temperature sensor.
Important: During the calibration process >no< needs to be set.
>yes<
curve.
The controller of the circulator uses the new calibration
59