Operating Manual - John Morris Scientific

Ultra-Low Refrigerated Circulators
6.3.1. Edit after start
A JULABO programmer of generation II allows editing of a running
profile. A programmer of the previous generation requested the profile to
be interrupted, edited and then started again.
>Edit Profile: 1
Step: 6
Setp: 100.00°C
Time [hh:mm] 01:05
Start and quit the edit mode:
After start, press the key to enter the submenu „Edit Profile“.
Press to quit the edit mode.
Deleting a complete section:
Use the keys to move to line 2.
Use the keys to choose the desired section.
Press the key to delete the complete section.
>Edit Profile: 1
**Step is deleted **
Setp: °C
Time [hh:mm]
>Edit Profile: 1
** Step is active **
Setp: 100.00°C
Time [hh:mm] 01:05
If the desired section is already chosen, the section is deleted even if
the cursor > is in line 1, 3 or 4.
Deletion is indicated in the respective line of the LCD display:
** Step is deleted **
The section that is currently processed cannot be deleted. If you still
try it, the message ** Step is active ** appears on the
LCD display.
Changing a section:
The values in lines 3 and 4 can be changed, even on the section that
is currently processed.
In the input window, select the menu item with the keys .
Use the numeral keypad to enter the numbers and press enter .
Edit Profile: 1
Step: 6
>Setp: 83.00°C
time [hh:mm] 01:25
Examples:
Setpoint: target temperature 83 °C
Time time period 1 hour:25 minutes
Particularity for changes in a section that is currently in process.
If the target temperature is changed, the slope of the ramp is
automatically calculated on basis of the remaining time of the
section.
If the time period is changed, the slope of the ramp is automatically
calculated on basis of the new total time of the section.
The „remaining total time“ (Profile x number of repetitions) as
described on page 42 can no longer be displayed.
43