819 Injection Module User's Guide (PDF) - John Morris Scientific

More documents

Recommendations

Info

Installation 2 Adjusting the Liquid Handler’s Z-Arm Height If you are using a 215 SW Liquid Handler The 215 SW Setup Utility is supplied on the 215 SW Utility Programs CD-ROM supplied with your 215 SW Liquid Handler. 1 Start the 215 SW Setup Utility. 2 To position the probe over the injection port, click Move to Port. 3 To see if the probe’s Z height is aligned correctly, slide a small piece of paper between the probe’s tip and the injection port. The probe is aligned if the top of the paper catches the tip of the probe when you position the paper between the probe and the injection port. 4 If the probe is not aligned, click on or to move the probe. 5 When the probe is aligned, click Ok to store the new alignment in the liquid handler’s memory. 5 Click on the About tab then Exit to close the 215 SW Setup Utility. Note: If the probe requires adjustment along the X- or Y-axis, use the Adjust XY tab. 2-18
Operation 3 You control the 819 Injection Module via an executable program being run on a computer or on the 215 Liquid Handler’s Keypad Controller. The program is generated by Gilson control software (ordered separately). 3-1
Page 1: 819 Injection Module User’s Guide
Page 4 and 5: 5 Troubleshooting Electrical ......
Page 7: Declaration of Conformity Applicati
Page 10 and 11: Introduction 1 Unpacking Unpacking
Page 12 and 13: Introduction 1 Technical Specificat
Page 14 and 15: Introduction 1 Technical Specificat
Page 16 and 17: Installation 2 Installing the Injec
Page 18 and 19: Installation 2 Making Electrical Co
Page 26 and 27: Installation 2 Adjusting the 215’
Page 28 and 29: Installation 2 Adjusting the Liquid
Page 30 and 31: Installation 2 Adjusting the Liquid
Page 34 and 35: Operation 3 Front Panel Front Panel
Page 37 and 38: Maintenance 4 To obtain optimum per
Page 39 and 40: Maintenance 4 Replacing Parts Repla
Page 41 and 42: Maintenance 4 Replacing the Injecti
Page 43 and 44: Maintenance 4 Replacing a Fuse A bl
Page 45 and 46: Troubleshooting 5 5-1
Page 47 and 48: Troubleshooting 5 Unit Not Operatio
Page 49 and 50: Troubleshooting 5 Repair and Return
Page 51 and 52: Replacement Parts and Accessories A
Page 53 and 54: Appendix A 251773 Prep FC package (
Page 55: Appendix A 49942107 0.8 mm ID Teflo
Page 58 and 59: Appendix B GSIOC Commands GSIOC Com
Page 61 and 62: Baud Rate C As a default, the baud
Page 63 and 64: Specifications Methods D This appen
Page 65 and 66: Appendix D Mobile Phase/Rinse Solve
Page 67 and 68: Appendix D Injection Reproducibilit
Page 69 and 70: Using an Additional 819 Module for
Page 71 and 72: Appendix E Electrical Connections M
Page 73 and 74: Appendix E Using an Additional 819
Page 75: Appendix E Example UniPoint Method

819 Injection Module User's Guide (PDF) - John Morris Scientific

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?