simrad dd15 - Chicago Marine Electronics

More documents

Recommendations

Info

Installation Direct drive in combination with rack and pinion system In principle the installation in combination with a rack and pinion system is the same as the standard installation except for the fact that the complete setup is rotated with the steering offset angle β. First install the rack and pinion system with the correct geometry, put the rudder amidships and find the line perpendicular to the tiller lever center line. Put the drive on a parallel line with an offset distance as in below table. Rotate the drive lever to the same offset angle as the steering system offset angle β and mount the draglink. Operating centers in mm valid for 72° (2x36°) rudder travel. Output center Offset distance Tiller center 130 106 200 165 127 250 rudder stock pedestal direct drive tiller arm draglink stop plate output lever Figure 3-5 Drive unit in combination with rack and pinion system - side view 20222303 / A 15
Simrad DD15 Direct Drive offset Figure 3-6 Drive unit in combination with rack and pinion system – top view 16 20222303 / A
Page 1 and 2: Manual Simrad DD15 Direct Drive Eng
Page 3 and 4: Simrad DD15 Direct Drive About this
Page 5 and 6: Simrad DD15 Direct Drive This page
Page 7 and 8: Simrad DD15 Direct Drive 1.2 How to
Page 9 and 10: Simrad DD15 Direct Drive 1.4 Compat
Page 11 and 12: Simrad DD15 Direct Drive • The hi
Page 13 and 14: Simrad DD15 Direct Drive A good ins
Page 15: Simrad DD15 Direct Drive Examples o
Page 19 and 20: Simrad DD15 Direct Drive 3.2 Electr
Page 21 and 22: Simrad DD15 Direct Drive 4 MAINTENA
Page 23 and 24: Simrad DD15 Direct Drive Figure 5-2
Page 25 and 26: Simrad DD15 Direct Drive 24 2022230

simrad dd15 - Chicago Marine Electronics

Create successful ePaper yourself

Delete template?

Save as template?