Installation Instructions - Jegs
Installation Instructions - Jegs
Installation Instructions - Jegs
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
HyperPAC User Manual<br />
11. If the data was entered correctly and you wish to use this data for the track<br />
calibration, touch OK. If at any time in the future you wish to no longer use this time for<br />
a track calibration , return to this review screen and uncheck the “Use this Data” box.<br />
After touching OK, the unit will return to the “Run Setup” screen.<br />
12. If you intend to use only one run for your calibration, touch END SESSION. But if<br />
you are using more runs for calibration, touch NEXT RUN, then touch TRACK<br />
CALIBRATION, and keep repeating these procedures until all runs have been entered.<br />
When you are finished, touch END SESSION.<br />
13. The track calibration is now automatically active and will take effect on all<br />
subsequent runs.<br />
14. If at any time in the future, you wish to either remove this calibration or calibrate<br />
your HyperPAC to a different track, simply return to the calibration verification screen<br />
(located where ) and un-check the Use this Data check box for each run you entered<br />
during the calibration procedure .<br />
15. This removes the track calibration, and you may recalibrate for a different track, if<br />
you choose. Unless or until you do a recalibration, all of your subsequent test results<br />
www.hypertech.com • (901) 382-8888 Page 47 of 66
Change language