Bully Dog 40300 Computer Chip Programmer Installation ... - Jegs

Appendix
APPENDIX
Section 4: PMT Troubleshooting
CONDITION POSSIBLE SOURCES ACTION
PMT will not turn on
Installation/ Connections
Make sure that the fuse jack is securely fastened to the
fuse socket.
Check that the fuse is working properly.
Make sure that all of the harnesses are properly installed. If
still not working, one of the harnesses could be defective.
Check and ensure the proper truck is selected.
Will only display pyrometer Improper Truck Selection Make sure you have proper connections everywhere.
Also, make sure that there are no bent pins in any of the
connectors.
Will not adjust horsepower Improper Truck Selection Check and ensure the proper truck is selected.
Back light quit working Loose Connections
Contact Technical Support if the PMT is otherwise functioning
normal.
PMT will not display proper
temperature EGTs
Pyrometer Probe
Connections Incorrect
Check the orientation of the Pyrometer connections on
the PCH to ensure that the Pyrometer leads are properly
connected.
For more information on up-to-date troubleshooting guide for the PMT, go to
www.bullydog.com/Product_Updates.php
PMT error codes:
For error code information regarding any error codes that appear while operating the PMT visit the
web address below:
www.bullydog.com/PMT_Tech.php
Introduction Parts Description PMT Installation Operating Instructions Internet Updates
66