Bully Dog 40300 Computer Chip Programmer Installation ... - Jegs

OPERATING INSTRUCTIONS
CHANGE VEHICLE:
The Vehicles Menu is only used for two reasons:
1. The PMT is being transferred to a new vehicle, in which case it is very important that you make sure that
the last vehicle was completely returned to stock before the transfer. The PMT will not work on the new
vehicle unless the last vehicle was returned to stock.
2. If the wrong vehicle is selected when performing an install on a new vehicle during the Setup Wizard,
you will have to use the Vehicles Menu to select the correct vehicle.
Go Back
to Main Menu
VEHICLES
‘03-’07 Ford 6.0L Power Stroke
‘03-’05 Dodge 5.9L Cummins
‘06-’07 Dodge 5.9L Cummins
‘01-’05 GM 6.6L Duramax
‘06-’07 GM 6.6L Duramax
To select a different vehicle, press the selection
button that coincides with that vehicle
location.
Use the large Up Down Buttons to move
between different vehicles.
When you select a new vehicle type in the Change Vehicle Menu and intend to install a download
into the vehicle you will need to do so through the Install Download Submenu from the
Main Menu.
THE SD CARD MUST BE INSERTED IN THE SIDE OF THE PMT TO CHANGE VEHICLES.
Introduction Parts Description PMT Installation Operating Instructions
Internet Updates Appendix
36