Bully Dog 40300 Computer Chip Programmer Installation ... - Jegs
Bully Dog 40300 Computer Chip Programmer Installation ... - Jegs
Bully Dog 40300 Computer Chip Programmer Installation ... - Jegs
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
PMT INSTALLATION<br />
Post-turbo MOUNT<br />
1. Find a location on the exhaust pipe that is 3-6”<br />
downstream from the turbo charger output. Then<br />
drill a 5 /16” hole and run a 1 /8” pipe tap into the hole.<br />
Mount the Pyrometer Probe in the threaded hole<br />
using a 9 /16” wrench to tighten the probe holder or<br />
tube fitting to the down tube. Then tighten the<br />
Pyro Probe Cap to the holder using a 5 /8” wrench.<br />
2. Run the Pyro Cable along the brim of the engine<br />
bay, and then let the end sit when installing the<br />
PCH Board.<br />
Dodge Post-turbo Mount<br />
Securing pyro line<br />
Pyro line secured<br />
Introduction Parts Description PMT <strong>Installation</strong><br />
Operating Instructions Internet Updates Appendix<br />
22