Operating Instructions - Jaken Medical...
Operating Instructions - Jaken Medical...
Operating Instructions - Jaken Medical...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Equipment Setup<br />
Using the Battery (Eclipse Plus)<br />
CALIBRATION AND CHARGING THE BATTERY<br />
NOTE: The battery that is shipped with the Eclipse Plus is not<br />
fully charged. To prepare the Eclipse Plus for normal use, follow<br />
the procedure below to calibrate the Battery Status gauge and<br />
charge the battery.<br />
1. Unplug the Eclipse from AC line power.<br />
2. Press ON/STBY to turn the Eclipse on. Press M to go to the<br />
Main menu. Press B, then press Enter to turn on the Battery<br />
Exercise Mode.<br />
3. Fully discharge the battery by operating the unplugged unit<br />
until the unit powers down from lack of power.<br />
4. Ensure that the battery is discharged by pressing the<br />
On/Standby key. If the unit does not turn on or if it powers<br />
down within a few seconds, the battery is discharged.<br />
5. Reconnect AC power to fully recharge the battery in about 5<br />
hours.<br />
NOTE: You may operate the Eclipse from AC line power<br />
while the battery is charging. However, this will increase<br />
charging time.<br />
+<br />
WHEN TO CHARGE THE BATTERY<br />
During operation of the Eclipse Plus, the Battery Status gauge in the PREVIEW<br />
screen tracks battery charge status (see Figure 3-2 on pg. 3-4). When all 8 bars<br />
are lit, the battery is fully charged. When battery power is being used, the<br />
message ÒBATTERYÓ is displayed and the minus sign ( - ) is highlighted<br />
indicating that charge is being drained. When the unit is connected to AC line<br />
power, the message ÒAC ONÓ is displayed and the plus sign ( + ) is highlighted<br />
indicating the battery is charging.<br />
When fewer than 15 minutes of operating time remain, the message ÒLOW<br />
BATTERYÓ ßashes and the unit beeps every 30 seconds. If the battery charge<br />
level drops too low, the unit displays the message, ÒPOWERING DOWN.Ó<br />
Then, after 5 seconds, the unit shuts off. Connect the unit to AC line power at<br />
this point to operate the unit and recharge the battery (the battery fully<br />
recharges in about 5 hours).<br />
NOTE: Under extreme conditions, the unit may not have<br />
enough battery power to power up. If the unit beeps 3 times or<br />
displays the message, ÒBattery Low-Please ChargeÓ when<br />
powering up, then plug the unit into AC line power and<br />
recharge the battery for 5 hours.<br />
Eclipse <strong>Operating</strong> <strong>Instructions</strong> 2-5