Operating Instructions - Jaken Medical...
Operating Instructions - Jaken Medical...
Operating Instructions - Jaken Medical...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Chapter 2<br />
Equipment Setup<br />
Figure 2-1<br />
Eclipse Back Panel<br />
A<br />
B<br />
C<br />
D<br />
Eclipse Plus Back Panel<br />
G<br />
F<br />
E<br />
A<br />
D<br />
Eclipse 850 Back Panel<br />
G<br />
F<br />
E<br />
IOIO<br />
(A) SERIAL PORT<br />
(ECLIPSE PLUS & 850 WITH COMMUNICATIONS)<br />
Connect compatible fax/modems to this serial connector using an approved<br />
modem cable. You must have the fax or SCP-ECG software installed to use this<br />
function.<br />
Most Hayes-compatible modems supporting Fax Service Class 2 commands<br />
will work with the Eclipse.<br />
This connector is also used for direct connection of the unit to a compatible<br />
management system using an approved Direct Connect cable.<br />
(OR)<br />
RJ11<br />
(B) EXPANSION (ECLIPSE PLUS)<br />
This connector is reserved for future expansion.<br />
(C) INTERNAL MODEM<br />
(ECLIPSE PLUS & 850 WITH COMMUNICATIONS)<br />
Connect the phone line you will be using for faxing or sending records into this<br />
RJ11 connector if your unit is equipped with an internal fax/modem. (On the<br />
Eclipse 850, this connector is located on the left side of the unit, if you are facing<br />
the unit. See Figure 2-2 on pg. 2-3.)<br />
2-2 Eclipse <strong>Operating</strong> <strong>Instructions</strong>