MAC ® 1200 Operations Manual - Jaken Medical...

System Setup
9.8 Option Code
In this menu you enter the option codes to enable a
number of optional software functions. The respective
option becomes active after you have entered
the code number. The code numbers are listed on the
option code sheet supplied with the different software
options.
• In the setup menu, position the bar cursor on
"Option Code" and confirm the selection with
.
The option code menu appears. There is a choice of
6 options:
MEAS: measurement of the 10-second resting
ECG
DIAG: measurement and interpretation of the 10-
second resting ECG
MEMO: program for storage of up to 40 resting
ECGs
C100: activates the three options MEAS, DIAG,
MEMO for a maximum of 100 ECGs
C500: activates the three options MEAS, DIAG,
MEMO for a maximum of 500 ECGs
EVAL: activates the three options MEAS, DIAG,
MEMO for a maximum of 4 weeks
• Position the bar cursor on the option you wish to
activate.
• Enter the 12-digit code number from the keyboard
and confirm the entry with .
The unit will accept the entered number only if it
corresponds to the unit's serial number. The serial
number is indicated at the top of the menu (Ser.No.
= xxxxxxxxx). This number must be the same as
printed on the nameplate (back of the device).
When you enter the code number for DIAG and
MEMO, the fields for C100, C500 and EVAL will
disappear.
9.9 ECG Transmission via Modem
• Select the 12 Lead Mode and press setup .
• Press to display the setup menu for the 12
Lead Mode.
• Use the cursor keys to position the bar cursor on
"Manual copy to HOST" and confirm the selection
with ([HOST]).
• Press
to clear the setup menu.
• Use the cursor keys to position the bar cursor on
"Communication" and confirm the selection with
.
Selecting the Communication Protocol
• Using the cursor keys, position the bar cursor on
"Protocol". Select the protocol CSI to send data
to a MUSE CV Information System, or select A5
if you will send data to CardioSys/CardioSoft.
• Use the cursor keys to position the bar cursor on
"Modem, other" and confirm the selection with
.
• Choose the modem you use from the list and
confirm the selection with .
If your modem is not included in the list, select
"other" and enter the required modem commands
(see also "Modem Setup" in section 5.7).
• When you have selected a standard modem, position
the bar cursor on "Dial mode" and select the
appropriate mode.
• Enter the telephone number of the receiving
modem and the number to access the public telephone
network and terminate the setup with
.
• Exit the menu with .
227 492 04-F MAC® 1200 55