MAC ® 1200 Operations Manual - Jaken Medical...

Recording in 12 Lead Mode
5.5.5 Receiving Data with the CSI Communication
Protocol
Initializing modem . . . .
Cancel : [ START / STOP]
Figure 5-15. Screen display after activation of
and copy
Modem initialized
Waiting for ECG data : [ ENTER ]
Cancel : [ START / STOP]
Figure 5-16. Screen display after modem initialization
12Lead/REC 60Hz ADS
4x2.5R1 10mm/mV Standard
Figure 5-17. Unit is ready to receive data
Receiving ECG . . . . 1
Cancel : [START / STOP]
(see also chapter 13 "Technical Specifications")
Receiving ECGs is only possible in the 12Lead
Mode.
• Use the key combination and copy to display
the screen for receiving ECGs (Figure 5-15). The
connected modem is automatically initialized.
The procedure can be aborted with .
• Press to enable the "receive data" mode. The
procedure can be aborted with .
When you have enabled the "receive data" mode, the
standard screen display of the 12 Lead Mode displays.
The message "12Lead/REC" indicates that the
unit is ready to receive data (Figure 5-17).
ECGs can be recorded in the 12 Lead Mode even
while the unit is in the "receive data" mode.
A message displays on the screen when the unit is
receiving data (Figure 5-18). The reception can be
aborted with .
The ECG which has just been received is processed
for the printout. The report is printed in the selected
format. Multiple ECGs are received and printed one
after the other.
After printout of the last ECG, the "receive data"
mode is automatically disabled. The mode is also
disabled when you select another operating mode.
The following information is annotated in the bottom
line of each report:
– the sender
– the software version and analysis program version
used at the sending unit (e.g. ACQ-DEV:
M1200 V5.1M12i 12SL V13).
Figure 5-18. Unit is receiving ECG 1
227 492 04-F MAC® 1200 37