MAC ® 1200 Operations Manual - Jaken Medical...

Recording in 12 Lead Mode
You will see the transmission menu as shown in
Figure 5-7.
• Check the displayed telephone number and press
to initiate the transfer.
Figure 5-7. Transmission menu
• If it is necessary to change the number, press setup
to display the setup menu.
• With , the transmission can be stopped.
As soon as you initiate the transmission with ,
the unit will automatically dial the number of the
modem at the receiving end and establish a connection
(Figure 5-8). Then it will send the ECG (Figure
5-9).
Figure 5-8. Initializing the transmission
After the transmission, a message on the display
indicates the number of successfully transmitted
ECGs. As soon as you acknowledge the message
with , the 12 Lead Mode acquisition screen
appears.
The system identifies ECGs that were successfully
sent to the host system with the letter "S" (1, Figure
5-3). All of these ECGs can be deleted with the
command "Delete transmitted ECGs".
Figure 5-9. Display during ECG transfer
If it is not possible to transmit the ECG (wrong
modem setup, modem off), the unit will display an
error message, such as "ECG Transmission Error!
(CSI)" (Figure 5-10).
In this situation you have the following choices:
− you can repeat the transmission with
Figure 5-10. Error message
− you can change the settings with setup
− you can stop the transmission with .
227 492 04-F MAC® 1200 33